BRTO
Circular protective louvre for duct end installation with welded wire mesh
OPTIMUS 60R
OPTIMUS60R is a fire damper, fire class EI60/EI60S with modulating actuator. This means it is possible to regulate the air flow from 0-100% with a control signal 2-10V, use it as an adjustment damper or boosting damper while providing complete protection against the spread of combustion gases.
Quick facts
• Fire resistance class EI60S
• Sizes from 100 mm to 630 mm
• Adapted for reuse
• Installed without fire sealant and insulation strip
• No refinishing
• Easy installation from one side of the building element
separating fire cells
• Available in MagiCAD
Accessories
-
-
FENIX 0-10V
Used for local modulating of 0-10V modulating fire dampers
-
FENIX+
Slave unit for FENIX4, used to extend with further 4 fire dampers (maximum 3pcs/FENIX4)
-
FENIX2
Monitoring system for up to 2 fire dampers
-
FENIX4
Monitoring system for up to 16 fire dampers
-
R30
Expansion module
-
RCBK4
Monitoring system for up to 4 fire dampers
-
RCBK4-MOD
Monitoring system for up to 4 fire dampers, with Modbus RTU
-
RCDU2
Monitoring system for up to 2 fire dampers
-
RCKD
Duct detector
-
RCMM
Minimaster
-
RCMU8
Monitoring system for up to 8 fire dampers
-
RCMU8_MOD
Monitoring system for up to 8 fire dampers, with Modbus RTU
-
RCRD
Room detector
-
RCRS
Monitoring system for 1 pcs modulating fire damper
-
RCTC
Central unit
-
RCTU
Damper module